LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Chrysler >> 2021 >> Voyager LX, Gas >> Repair and Diagnosis >> Brakes >> Parking Brake System >> Base Brakes (Service Information) >> Hydraulic/Mechanical >> Pads, Brake, Rear >> Removal And Installation >> Installation

Removal And Installation: Installation

  1. Using a suitable tool, push the brake caliper piston into the caliper housing.
    GC0177467Courtesy of CHRYSLER GROUP, LLC
  2. Position the inner and outer brake pads (1) in the caliper adapter bracket.
    GC0177768Courtesy of CHRYSLER GROUP, LLC
  3. Install the brake caliper on the caliper adapter bracket.
  4. Install the brake caliper fasteners (3) and tighten to the proper torque specifications. Refer to TORQUE SPECIFICATIONS  .
    GC0177879Courtesy of CHRYSLER GROUP, LLC
  5. Install the anti-rattle clip (1).
  6. Install the tire and wheel assembly. Refer to REMOVAL AND INSTALLATION .
  7. Remove the support and lower the vehicle.
  8. Connect the negative battery cable. If equipped with an Intelligent Battery Sensor (IBS), connect the IBS connector.
  9. Pump the brake pedal several times to ensure the vehicle has a firm brake pedal before moving the vehicle.
    NOTE:

    Be sure to exit Service Mode either with scan tool or by customer method of applying the EPB switch with the brake pedal depressed at the same time, before road testing.

  10. Road test the vehicle and make several stops to wear off any foreign material on the brakes and to seat the brake pads.
scientia non olet · About LEMON Manuals