Removal And Installation: Installation

Courtesy of CHRYSLER GROUP, LLC

Position the hub and bearing in the steering knuckle.
Install NEW hub and bearing to knuckle mounting fasteners (1) and tighten to the proper torque specifications. Refer to FRONT, TECHNICAL SPECIFICATIONS .

Courtesy of CHRYSLER GROUP, LLC
Engage the wheel speed sensor wire to the retainer (1) on the knuckle.

Courtesy of CHRYSLER GROUP, LLC
Connect the wheel speed sensor wire harness connector (1).
Attach the wheel speed sensor wire retainers (3) on the strut and attach the wheel speed sensor wire retainers (2) to the brake line.

Courtesy of CHRYSLER GROUP, LLC
Install the splash shield (1) and tighten the mounting fasteners (2) to the proper torque specifications. Refer to SHIELD, SPLASH, FRONT WHEELHOUSE or SHIELD, SPLASH, REAR WHEELHOUSE .

Courtesy of CHRYSLER GROUP, LLC
Install a NEW front hub nut (2). While a helper applies the brakes to keep the hub from turning, and tighten to the proper torque specifications. Refer to TORQUE SPECIFICATIONS .
NOTE:
Do not over-torque the hub nut.
Install the front brake rotor. Refer to ROTOR, BRAKE, REMOVAL AND INSTALLATION .
Install the tire and wheel assembly. Refer to REMOVAL AND INSTALLATION .
If necessary, perform a wheel alignment. Refer to WHEEL ALIGNMENT, STANDARD PROCEDURE .