LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Chrysler >> 2021 >> Voyager LX, Gas >> Repair and Diagnosis >> Restraints >> Seat Belts >> Restraints System (Service Information) >> Retractor, Seat Belt >> Removal And Installation >> Front >> Installation

Removal And Installation: Front: Installation

GC0177315Courtesy of CHRYSLER GROUP, LLC
NOTE:

The following procedure is for replacement of an ineffective or damaged seat belt and retractor unit. The front retractor also includes a seat belt tensioner. If the front seat belt or retractor is ineffective or damaged, but the seat belt tensioner is not deployed, review the recommended procedures for Handling Non-Deployed Supplemental Restraints. Refer to STANDARD PROCEDURE . If the seat belt tensioner has been deployed, review the recommended procedures for Service After A Supplemental Restraint Deployment before removing the unit from the vehicle. Refer to STANDARD PROCEDURE .

  1. Position the seat belt retractor unit (4) to the B-pillar by engaging the T-tab on the retractor bracket into the notch in the inner B-pillar and align the anchor tensioner with the mounting hole in the B-pillar.
  2. Install the screw (3) that secures the retractor bracket and anchor tensioner to the base of the inner B-pillar. Tighten the screw to the proper. Refer to TECHNICAL SPECIFICATIONS .
  3. Position the seat belt turning loop (2) onto the height adjuster. Be certain that the seat belt webbing between the retractor and the turning loop is not twisted.
  4. Install the nut (1) that secures the turning loop to the height adjuster. Tighten the nut to the proper. Refer to TECHNICAL SPECIFICATIONS .
  5. Install the retractor belt guide (5) to the inner B-pillar.
    GC0177275Courtesy of CHRYSLER GROUP, LLC
  6. Restore the cover (1) over the top of the seat belt turning loop (2).
    GC0177960Courtesy of CHRYSLER GROUP, LLC
  7. Connect the three body wire harness connectors (2) to the initiators for the two tensioners and the adaptive load limiter.
  8. Install the middle and lower trim onto the inside of the B-pillar. Refer to PANEL, B-PILLAR TRIM, LOWER, REMOVAL AND INSTALLATION .
  9. Be certain that the seat belt webbing between the turning loop and the lower anchor buckle is not twisted.
  10. Do not connect the negative battery cable at this time. The Supplemental Restraint System (SRS) Verification Test procedure should be performed following service of any SRS component. Refer to STANDARD PROCEDURE .
scientia non olet · About LEMON Manuals