Diagnostic Test

CHECK FOR AN ACTIVE DTC
1. With the scan tool, read RBSS DTCs and record on the repair order.
2. With the scan tool, erase DTCs.
3. Using the recorded Environmental Data, along with the When Monitored and Set Conditions above, operate the vehicle in the conditions that set the DTC.
4. With the scan tool, read RBSS DTCs.
  Did the DTC return?
  
  Yes
  - Go To 2
  No
  - Perform the TESTING FOR AN INTERMITTENT CONDITION procedure. Refer to TESTING FOR AN INTERMITTENT CONDITION .
VERIFY OPERATION OF THE VEHICLE CHARGING SYSTEM
NOTE:
Troubleshoot any PCM charging/cranking DTCs before proceeding.

NOTE:
Make sure the battery is fully charged.

Are any charging system DTCs present?

Yes
- Refer to DTC INDEX and perform the appropriate diagnostic procedure.
No
- Replace the Blind Spot Sensor in accordance with the Service Information. Refer to SENSOR, BLIND SPOT, REMOVAL AND INSTALLATION .
- Perform the BODY VERIFICATION TEST. Refer to BODY VERIFICATION TEST .