Diagnostic Test

CHECK FOR AN ACTIVE DTC
1. With the scan tool, read RBSS DTCs and record on the repair order.
2. With the scan tool, erase DTCs.
3. Using the recorded Environmental Data, along with the When Monitored and Set Conditions above, operate the vehicle in the conditions that set the DTC.
4. With the scan tool, read RBSS DTCs.
  Did the DTC return?
  
  Yes
  - Go To
  No
  - Perform the TESTING FOR AN INTERMITTENT CONDITION procedure. Refer to TESTING FOR AN INTERMITTENT CONDITION .
PROXI CONFIGURE THE RBSS
1. With the scan tool, perform the Proxi Configuration Alignment routine.
2. With the scan tool, erase DTCs.
3. Cycle the ignition switch from off to on at least five times.
4. With the scan tool, read DTCs.
  Did the DTC return?
  
  Yes
  - Replace the Right Blind Spot Sensor (RBSS) in accordance with the service information. Refer to SENSOR, BLIND SPOT, REMOVAL AND INSTALLATION .
  - Perform the BODY VERIFICATION TEST. Refer to BODY VERIFICATION TEST .
  No
  - Test complete.
  - Perform the BODY VERIFICATION TEST. Refer to BODY VERIFICATION TEST .