Inner Tie Rod End: Removal

NOTE:

If removing the right side inner tie rod repeat steps 1-6 for the left inner tie rod.

NOTE:

The bellows and clamps are not reusable and must be DISCARDED if removed.

Remove outer tie rod end. Refer to TIE ROD, STEERING, REMOVAL AND INSTALLATION .
Remove the jam fastener from the inner tie rod.

Courtesy of CHRYSLER GROUP, LLC
Remove clamp (1) securing bellows (2) to inner tie rod and DISCARD .
Remove clamp (3) securing bellows (2) to steering gear body and DISCARD .
Remove the bellows (2) from the inner tie rod end and DISCARD .

Courtesy of CHRYSLER GROUP, LLC
Install the EPS steering rack holder
(special tool #10417, Holder, EPS Steering Rack)

(2) on the LH inner tie rod. Using a suitable tool (1), remove the inner tie rod.

NOTE:
The EPS Steering Rack Holder can only be installed to the left side of the steering gear.

CAUTION:
If the inner tie rod cannot be removed using the specified tools, do not use a hammer or heat to loosen. Damage to the steering gear will occur. Replace the entire steering gear.
Unthread and remove the inner tie rod from the rack gear.