Third Row Outboard: Removal
To avoid serious or fatal injury during and following any seat belt or child restraint anchor service, carefully inspect all seat belts, buckles, mounting hardware, retractors, tether straps, and anchors for proper installation, operation, or damage. Replace any belt that is cut, frayed, or torn. Straighten any belt that is twisted. Tighten any loose fasteners. Replace any belt that has a damaged or ineffective buckle or retractor. Replace any belt that has a bent or damaged latch plate or anchor plate. Replace any child restraint anchor or the unit to which the anchor is integral that has been bent or damaged. Never attempt to repair a seat belt or child restraint component. Always replace damaged or ineffective seat belt and child restraint components with the correct, new and unused replacement parts listed in the Mopar® Parts Catalog. Failure to follow these instructions may result in possible serious or fatal injury.
- Remove the appropriate left or right trim panel (1 or 2) to access the seat belt lower anchor bolt.
- Remove the fastener (1) that secures the third row outboard seat belt lower anchor (2) near the rear of the wheel housing.
- Remove the appropriate left or right quarter trim panel and D-pillar trim panel. Refer to PANEL, QUARTER TRIM, REMOVAL AND INSTALLATION
.
- Remove the fastener (2) that secures the seat belt turning loop (1) to the D-pillar.
- Remove the fastener (4) that secures the retractor (3) to the bracket (5) on the D-pillar.
- Remove the third row outboard seat belt and retractor from the vehicle as a unit.
