Second Row Center: Removal
To avoid serious or fatal injury during and following any seat belt or child restraint anchor service, carefully inspect all seat belts, buckles, mounting hardware, retractors, tether straps, and anchors for proper installation, operation, or damage. Replace any belt that is cut, frayed, or torn. Straighten any belt that is twisted. Tighten any loose fasteners. Replace any belt that has a damaged or ineffective buckle or retractor. Replace any belt that has a bent or damaged latch plate or anchor plate. Replace any child restraint anchor or the unit to which the anchor is integral that has been bent or damaged. Never attempt to repair a seat belt or child restraint component. Always replace damaged or ineffective seat belt and child restraint components with the correct, new and unused replacement parts listed in the Mopar® Parts Catalog. Failure to follow these instructions may result in possible serious or fatal injury.
- Disconnect the seat belt (1) from the lower anchor (2).NOTE:
It is not necessary to completely remove the headliner from the vehicle. Lowering it to rest on the seat backs will allow access to the fasteners for the second row seat belt retractor nuts and bolt.
- Lower the headliner. Refer to HEADLINER, REMOVAL AND INSTALLATION .
- If equipped, remove the rear sunshade from the roof interior. Refer to SUNSHADE, SUNROOF, REMOVAL AND INSTALLATION
.
- Remove the fasteners (1) that secures the second row center rear seat belt upper anchor plate (2) to the roof bracket (3).
- Remove the fasteners (3) that secure the second row center seat belt retractor (1) to the rear header (2).
- Remove the second row center seat belt and retractor from the vehicle as a unit.
