Removal And Installation: Removal
WARNING:
Disable the airbag system before attempting any steering wheel, steering column, or instrument panel component diagnosis or service. Disconnect and isolate the negative battery (ground) cable, then wait two minutes for the airbag system capacitor to discharge before performing further diagnosis or service. This is the only sure way to disable the airbag system. Failure to take the proper precautions may result in an accidental airbag deployment and possible serious or fatal injury.
- Disconnect and isolate the negative battery cable. If equipped with an Intelligent Battery Sensor (IBS), disconnect the IBS connector first before disconnecting the negative battery cable.
- Remove the grille defroster. Refer to GRILLE, DEFROSTER, REMOVAL AND INSTALLATION
.
- Using a trim stick or equivalent, release the four retaining clips (1) on the instrument panel courtesy lamp (2).
- Disconnect the wire harness connectors.
- Using a small flat bladed tool, release the two tabs (2) and remove the sun sensor (1).
