Removal And Installation: Removal
When removing the fuel supply line from the fuel inlet tube at the fuel rail, care must be taken that the fuel inlet tube is not being over-flexed. Damage to the fuel rail inlet tube may occur.
The fuel system is under constant pressure even with engine off. Before servicing the fuel rail, fuel system pressure must be released.
- Release the fuel system pressure. Refer to FUEL DELIVERY, GAS, STANDARD PROCEDURE .
- Remove the upper intake manifold. Refer to MANIFOLD, INTAKE, REMOVAL AND INSTALLATION
.
- Remove the insulator (1) from the left cylinder head cover.
- Disconnect the fuel injector wire harness connectors (1).
- Disconnect the fuel supply hose (1) from the fuel rail. Refer to FITTING, QUICK CONNECT, STANDARD PROCEDURE .CAUTION:
The left and right fuel rails are replaced as an assembly. Do not attempt to separate the rail halves at the connector tube. Due to the design of this tube, it does not use any clamps. Never attempt to install a clamping device of any kind on the tube. When removing the fuel rail assembly for any reason, be careful not to bend or kink the tube.
- Remove the fasteners (1) from the fuel rail.CAUTION:
When removing the fuel rail from the lower intake manifold, one or more fuel injectors may remain in the intake manifold resulting in residual fuel spilling onto the engine from the fuel rail.
- Lift the fuel rail and the fuel injectors from the lower intake manifold.
- If required, remove any remaining fuel injectors (1) from the lower intake manifold.
- If required, remove the fuel injectors from the fuel rail. Refer to INJECTOR(S), FUEL, REMOVAL AND INSTALLATION .
- If required, remove and discard all fuel injector O-ring seals (1).
