Removal And Installation: Installation
- Position the PDC lower cover in the engine compartment and tighten the fasteners (1) to the proper torque specification. Refer to TECHNICAL SPECIFICATIONS .
- Connect the three bulkhead wire harness connectors (1) located in the base of the PDC to the upper PDC tray bottom.
- Tighten the fasteners (2) through the upper PDC tray to the proper torque specifications. Refer to TECHNICAL SPECIFICATIONS . If a screw is over torqued, mating connector can be damaged.
- Connect the B+ to the PDC (1) and tighten to the proper torque specifications. Refer to TECHNICAL SPECIFICATIONS .
- Install the PDC cover (1) onto the PDC assembly making sure the snap retainers (2) are fully engaged.
- Connect the negative battery cable. If equipped with an Intelligent Battery Sensor (IBS), connect the IBS connector.
