LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Chrysler >> 2021 >> Voyager LX, Gas >> Repair and Diagnosis >> Drivelines & Axles >> Wheel Hubs >> Rear Suspension >> Hub And Bearing >> Removal And Installation >> AWD >> Installation

Removal And Installation: AWD: Installation

  1. Position the hub and bearing assembly to the knuckle.
    GC0200390Courtesy of CHRYSLER GROUP, LLC
  2. Install the four hub and bearing to knuckle mounting fasteners (1) and tighten to the proper torque specifications. Refer to TECHNICAL SPECIFICATIONS .
    GC0178073Courtesy of CHRYSLER GROUP, LLC
  3. Install the wheel speed sensor into the wire retainers (2) along the camber link.
  4. Connect the wheel speed sensor to the vehicle harness connector (1).
  5. Install the rear brake rotor. Refer to ROTOR, BRAKE, REMOVAL AND INSTALLATION .
    GC0200324Courtesy of CHRYSLER GROUP, LLC
  6. Install the half shaft nut (1).
  7. Have a helper apply brake pressure and tighten the half shaft nut (1) to the proper torque specifications. Refer to TORQUE SPECIFICATIONS  .
  8. Install the tire and wheel assembly. Refer to REMOVAL AND INSTALLATION .
  9. Remove the support and lower the vehicle.
  10. Connect the negative battery cable. If equipped with an Intelligent Battery Sensor (IBS), connect the IBS connector.
scientia non olet · About LEMON Manuals