Removal And Installation: Installation
NOTE:
In any instance where a bolt is through a rubber bushing, the bolt must be torqued with the vehicle at normal ride height.
- Align the stabilizer bar link upper fastener hole to the knuckle then install stabilizer bar link upper fastener (1) but do not tighten at this time .
- Insert the stabilizer bar link ball stud into the stabilizer bar then install the stabilizer bar link lower fastener (2) but do not tighten at this time .
- Remove the support and lower the vehicle.
- Tighten the stabilizer bar link upper fastener (1) to the proper torque specification. Refer to TECHNICAL SPECIFICATIONS .
- Tighten the stabilizer bar link lower fastener (2) to the proper torque specification. Refer to TECHNICAL SPECIFICATIONS .