LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Chrysler >> 2021 >> Voyager LX, Gas >> Repair and Diagnosis >> Brakes >> Anti-Lock Brakes >> Anti-Lock Brake System (Abs) (Service Information) >> Electrical >> Sensor, Wheel Speed, Rear >> Removal And Installation >> Installation

Removal And Installation: Installation

CAUTION:

Ensure that sensor mounting surface on bearing is clean before sensor installation.

NOTE:

Apply bearing grease to the sensor head shaft and O-ring before installation.

GC0177985Courtesy of CHRYSLER GROUP, LLC
  1. Carefully install the rear wheel speed sensor (2) into the hub and bearing assembly.
  2. Install the rear wheel speed sensor mounting bolt (3) and tighten to the proper torque specifications. Refer to TORQUE SPECIFICATIONS  .
    GC0177765Courtesy of CHRYSLER GROUP, LLC
  3. Engage the wheel speed sensor wire (3) in the bracket.
  4. Install the rear brake rotor. Refer to ROTOR, BRAKE, REMOVAL AND INSTALLATION .
    GC0178073Courtesy of CHRYSLER GROUP, LLC
  5. Engage the wheel speed sensor wire retainers (2) onto the camber link.
  6. Connect the wheel speed sensor wire harness connector (1).
  7. Remove the support and lower the vehicle.
  8. Connect the negative battery cable. If equipped with an Intelligent Battery Sensor (IBS), connect the IBS connector.
  9. Perform the Diagnostic Verification Test and clear any faults that are present. Refer to DIAGNOSTIC TEST .
scientia non olet · About LEMON Manuals