Removal And Installation: Removal
- Using a trim stick or equivalent, lift the front edge of the scuff plate extension then pull forward to remove the three tabs from the quarter trim panel (1).
- Move the front seat to the full forward position.
- Spread the bottom flanges of the B-pillar extension apart to disengage the lower side snaps, then use a trim stick or equivalent to disengage the remaining two clips (3). Pull at the top edge seat belt opening to disengage the top four retainers (1).NOTE:
Disconnect the front seat position switch (2), if equipped.
- Pull inboard on upper edge of cover (4), then pull up to remove.
- Pull clips of B-Pillar Lower/Scuff (3) inboard with hands along each side of each clip.
- Use trim stick or equivalent, to disengage two forward edge clips of B-Pillar Lower/Scuff (1) from Cowl/Scuff (2) and lift at forward edge to disengage remaining four forward fasteners from wire trough.
- Lift up on rearward edge (5) of B-Pillar Lower/Scuff to disengage remaining six rearward fasteners from wire trough.
