Removal And Installation: Installation

Courtesy of CHRYSLER GROUP, LLC

Position the seat back cover to the seat back foam and engage the clip strips.
Pull the seat cover tight and engage the hook and loop fasteners.
Position the seat back cushion assembly on the seat frame.
Route the seat belt through the seat back cover and position the cushion assembly to the seat back frame.
Install the cover stiffeners (2) into the fold flat handle housing.
Install the screw (1) under the fold flat handle bezel.

Courtesy of CHRYSLER GROUP, LLC

NOTE:
The sleeve without the headrest cable has a metal retainer that needs to be installed first.
Install the headrest sleeve, then install metal clip retainer (1).

Courtesy of CHRYSLER GROUP, LLC
Pull the seat back cover tight and fasten all the J-hook fasteners (2).
Install the push fastener under the fold flat handle bezel (1).
Install the fold flat handle bezel and screw.
Install the headrest sleeves (3) and hand tap to engage the tabs.

Courtesy of CHRYSLER GROUP, LLC
Install the lower cover panel (2) and fasten the J-hook fasteners (1).

Courtesy of CHRYSLER GROUP, LLC
Install the inboard side shield (1) and the screw (2).

Courtesy of CHRYSLER GROUP, LLC
Install the outboard side shield (3) and the two screws (1).
Install the recline handle (2).
Install the armrest. Refer to ARMREST, FRONT, REMOVAL AND INSTALLATION or ARMREST, REAR, WITH RECLINE, REMOVAL AND INSTALLATION .
Install the headrest. Refer to HEADREST, STOW-N-GO, REMOVAL AND INSTALLATION or HEADREST, THIRD ROW, REMOVAL AND INSTALLATION or HEADREST, THIRD ROW, REMOVAL AND INSTALLATION .
Install the 2nd row Stow-N-Go seat. Refer to SEAT, STOW-N-GO, REMOVAL AND INSTALLATION .