Removal And Installation: Installation
- Position the instrument panel center trim panel and connect wire harness connector.
- Insert outboard end behind the A-pillar extension, then position the instrument panel center trim panel (2) and hand tap to engage the retaining clips.
- Install screw (1) into the instrument panel center trim panel and tighten securely.
- Position the media hub bezel (3) and hand tap to engage the retaining clips.
- Install the screw located in the media hub bezel opening, and tighten securely.
- Install the switch bank pod assembly (1).
- Connect the negative battery cable. If equipped with an Intelligent Battery Sensor (IBS), connect the IBS connector.
