LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Chrysler >> 2021 >> Voyager LX, Gas >> Repair and Diagnosis >> Body & Frame >> Exterior Body Panels >> Body - Interior & Exterior >> Doors - Front >> Handle, Exterior >> Removal And Installation >> Installation

Removal And Installation: Installation

GC0178322Courtesy of CHRYSLER GROUP, LLC
NOTE:

LH shown in illustration, RH typical.

  1. Connect the harness connector and position the handle (1) to the door.
  2. Slide handle (1) in and forward.
    NOTE:

    Visually confirm the bell crank has been reset correctly.

    GC0188587Courtesy of CHRYSLER GROUP, LLC
  3. The handle (1) will not be seated once installed.
    GC0188635Courtesy of CHRYSLER GROUP, LLC
  4. Position the door lock cylinder/trim cap (1) to the front door. Once properly positioned, tighten the PIA fastener accessible rearward of the handle securely and install the protective plug over the fastener opening.
  5. Pull on the handle (2) to fully seat it and check for proper operation.
  6. Connect the negative battery cable. If equipped with an Intelligent Battery Sensor (IBS), connect the IBS connector to the negative battery cable.
scientia non olet · About LEMON Manuals