Removal And Installation: Removal
WARNING:
Disable the airbag system before attempting any component diagnosis or service of the front seats, when equipped with front seat air bags. Disconnect and isolate the negative battery (ground) cable, then wait two minutes for the airbag system capacitor to discharge before performing further diagnosis or service. This is the only sure way to disable the airbag system. Failure to follow these instructions may result in accidental airbag deployment and possible serious or fatal injury.
- Remove the seat from the vehicle and place it on a workbench. Refer to SEAT, FRONT, REMOVAL AND INSTALLATION or SEAT, STOW-N-GO, REMOVAL AND INSTALLATION or SEAT, REMOVAL AND INSTALLATION or SEAT, REMOVAL AND INSTALLATION .
- Remove the front seat side shields. Refer to SIDE SHIELDS, SEAT CUSHION, FRONT, REMOVAL AND INSTALLATION .
- From under the seat disconnect the seatback heater wire harness connector (1) and unclip the harness (2).
- Disconnect the wire harness connectors, then remove the wire harness fasteners (1) and wire harness (2) from the seat cushion frame.
- Remove the two bolts (2) on each side of the seat and remove the seat back (1).
