Removal And Installation: Installation
NOTE:
It is recommended that both the Left Blind Spot Sensor (LBSS) and the Right Blind Spot Sensor (RBSS) part numbers are at the same revision level. The Blind Spot Monitor (BSM) system may not function properly if the revision levels of the LBSS and the RBSS part numbers are not synchronized.
- Slide the Left Blind Spot Sensor (LBSS) or Right Blind Spot Sensor (RBSS) in the mounting bracket on the rear bumper fascia.
- Check that the locking tab (2) is fully engaged.
- Connect the rear bumper fascia wire harness to the blind spot connector (1).
- Install the rear bumper fascia onto the vehicle. Refer to FASCIA, REAR, REMOVAL AND INSTALLATION .
- Connect the negative battery cable. If equipped with an Intelligent Battery Sensor (IBS), connect the IBS connector.