Removal And Installation: Outboard: Removal

Disconnect and isolate the negative cable from the battery. If equipped with an Intelligent Battery Sensor (IBS), disconnect the IBS connector before disconnecting the negative cable from the battery.
Remove the appropriate (front or rear) belly pan to gain access to the outboard park assist sensors. Refer to BELLY PAN, FRONT, REMOVAL AND INSTALLATION or BELLY PAN, REAR, REMOVAL AND INSTALLATION or BELLY PAN, REAR SUSPENSION, REMOVAL AND INSTALLATION .
If equipped, remove the appropriate (left or right) fog lamp. Refer to LAMP, FOG, REMOVAL AND INSTALLATION .

Courtesy of CHRYSLER GROUP, LLC

NOTE:
If either of the sensor bracket latch (2) features are damaged, fascia replacement is recommended.
From the back of the fascia, carefully pry the park assist sensor bracket latch (2) features away from the latch tabs of the sensor far enough to disengage the sensor (1) from the bracket.
Disconnect the wire harness connector (3) from the sensor connector receptacle.
Remove the sensor from the vehicle.