Diagnostic Test

CHECK FOR AN ACTIVE DTC 

1. Turn the ignition on.
2. With the scan tool, create a Vehicle Scan Report and attach it to the repair order.
3. Turn the ignition switch from On to Off.
4. Wait 30 seconds.
5. Turn the ignition on.
6. With the scan tool, read the PSDMR DTCs.

   Is the DTC active?

   Yes 

   • Replace the Right Power Sliding Door Module in accordance with service information. Refer to MODULE, DOOR (DDM/PDM), REMOVAL AND INSTALLATION or MODULE, DOOR, POWER SLIDING (PSDML/PSDMR), REMOVAL AND INSTALLATION .
   • Perform the BODY VERIFICATION TEST. Refer to BODY VERIFICATION TEST .

   No 

   • Perform the TESTING FOR AN INTERMITTENT CONDITION procedure. Refer to TESTING FOR AN INTERMITTENT CONDITION .
   • Operate the Right Power Sliding Door with several power open and close cycles. With the scan tool, read DTC's. If this code appears, replace the Right Power Sliding Door Module in accordance with service information. Refer to MODULE, DOOR (DDM/PDM), REMOVAL AND INSTALLATION or MODULE, DOOR, POWER SLIDING (PSDML/PSDMR), REMOVAL AND INSTALLATION .
   • Perform the BODY VERIFICATION TEST. Refer to BODY VERIFICATION TEST .