Diagnostic Test

INSPECT DRIVER DOOR SWITCH ASSEMBLY FOR DAMAGE
NOTE:
Diagnose and repair all LIN Bus related DTCs before performing this test procedure.
1. Turn the ignition off.
2. Inspect the Driver Window/Door Lock Switch for damage.
  Is the switch assembly damaged?
  
  Yes
  - Replace the Driver Window/Door Lock Switch in accordance with the Service Information. Refer to SWITCH, POWER WINDOW, REMOVAL AND INSTALLATION .
  - Perform BODY VERIFICATION TEST. Refer to BODY VERIFICATION TEST .
  No
  - Go To 2
INSPECT FOR OBJECT OR SUBSTANCE CAUSING MIRROR FOLD SWITCH TO STAY OR STICK IN A PUSHED POSITION
1. Inspect the Mirror Fold switch for anything that would cause it to stay or stick in a pushed position.
  Is anything present that would cause the Mirror Fold switch to stay or stick in a pushed position?
  
  Yes
  - Repair as necessary.
  - Perform BODY VERIFICATION TEST. Refer to BODY VERIFICATION TEST .
  No
  - Go To 3
CHECK FOR AN ACTIVE DTC
1. Turn the ignition on.
2. With the scan tool, record and erase the DTCs.
3. Operate the Mirror Fold switch several times and then wait 30 seconds.
4. With the scan tool, read DDM DTCs.
  Is the DTC active?
  
  Yes
  - Replace the Driver Window/Door Lock Switch in accordance with the Service Information. Refer to SWITCH, POWER WINDOW, REMOVAL AND INSTALLATION .
  - Perform BODY VERIFICATION TEST. Refer to BODY VERIFICATION TEST .
  No
  - Perform the TESTING FOR AN INTERMITTENT CONDITION procedure. Refer to TESTING FOR AN INTERMITTENT CONDITION .
  - Perform BODY VERIFICATION TEST. Refer to BODY VERIFICATION TEST .