Front Washer Nozzle: Installation
- Route the supply hose through the hood inner nozzle mounting hole and then position the front washer nozzle (1) to the mounting hole in the rear of the hood reinforcement panel.
- Align the locating flanges to the hood reinforcement panel and, using hand pressure, press the two nozzle flanges in place in the panel.
- Using hand pressure, push firmly and evenly on the bottom of the nozzle until the integral latch (1) snaps in place on the inside of the hood reinforcement panel.
- Route the supply hose through the hood inner nozzle hole and then connect the supply hose (2) to the front washer nozzle nipple.
- Install the hood insulation.
- Connect the negative battery cable. If equipped with an Intelligent Battery Sensor (IBS), connect the IBS connector.