Removal And Installation - Passenger Side: Installation
- Position the passenger KAB unit (1) below the instrument panel in a vertical orientation with the KAB inflator initiator connector receptacle facing upward.
- Connect the connector insulator (2) of the instrument panel wire harness take out for the passenger KAB to the inflator initiator connector receptacle by pressing straight in on the connector. You can be certain that the connector is fully engaged in its receptacle by listening carefully for a distinct, audible click as the connector latches snap into place.
- Carefully position the passenger KAB and cover (1) to the lower instrument panel support structure.
- Install the fasteners (2) that secure the passenger KAB and cover to the instrument panel support structure and tighten the fasteners to the proper. Refer to TECHNICAL SPECIFICATIONS .
- Install the footwell courtesy lamp to the passenger side of the instrument panel. Refer to LAMP, COURTESY, REMOVAL AND INSTALLATION .
- Do not connect the negative battery cable at this time. The Supplemental Restraint System (SRS) Verification Test procedure should be performed following service of any SRS component. Refer to STANDARD PROCEDURE .
