8-Way Driver Seat With Memory
- Disconnect and isolate the negative battery cable.
- Remove the power seat switch from the seat. Refer to SWITCH, SEAT, REMOVAL AND INSTALLATION .
- Use an ohmmeter to test the continuity of the power seat switch using the following table. If not OK, replace the inoperative power seat switch. If switch tests OK, check for an open or short in the power seat circuit wiring. If no open or short is found, replace the power seat track and pan assembly or seat back frame, as required.
8-WAY DRIVER SEAT SWITCH CONTINUITY - WITH MEMORY
| SWITCH POSITION | CONTINUITY BETWEEN | RESISTANCE VALUE |
|---|---|---|
| OFF | 10-4 | OPEN |
| OFF | 10-11 | OPEN |
| OFF | 1-4 | 47 OHMS |
| OFF | 1-11 | 47 OHMS |
| REAR TILT UP | 10-11 | 169 OHMS |
| REAR TILT DOWN | 10-11 | 76 OHMS |
| HORIZONTAL FORWARD | 10-11 | 43 OHMS |
| HORIZONTAL REARWARD | 10-11 | 10 OHMS |
| RECLINER UP | 10-4 | 43 OHMS |
| RECLINER DOWN | 10-4 | 10 OHMS |
| FRONT TILT UP | 10-4 | 169 OHMS |
| FRONT TILT DOWN | 10-4 | 76 OHMS |
| ALL RESISTANCE VALUES ARE ± FIVE PERCENT | ||