Removal And Installation: Removal

Disconnect and isolate the negative battery cable. If equipped with an Intelligent Battery Sensor (IBS), disconnect the IBS connector first before disconnecting the negative battery cable.
Raise and support the vehicle. Refer to HOISTING, STANDARD PROCEDURE .

Courtesy of CHRYSLER GROUP, LLC
Disconnect the rear wheel speed sensor wire harness connector (1).
Disengage the wheel speed sensor wire retainers (2) from the camber link.
Remove the rear brake rotor. Refer to ROTOR, BRAKE, REMOVAL AND INSTALLATION .

Courtesy of CHRYSLER GROUP, LLC
Disengage the wheel speed sensor wire (3) from the bracket.

Courtesy of CHRYSLER GROUP, LLC

CAUTION:
Prior to removal, clean area around sensor head to help prevent contaminants from entering bearing when sensor head is removed.
Remove the rear wheel speed sensor bolt (3).
Carefully remove the wheel speed sensor (2) from the hub and bearing assembly and from the vehicle.