Diagnostic Test

CHECK FOR RELATED DTCS
1. Turn the ignition on.
2. With the scan tool, create a Vehicle Scan Report and attach it to the repair order.
3. With the scan tool, read the PDM DTCs.
  Does the scan tool display any window control circuit, window position sensor or battery voltage DTCs?
  
  Yes
  - Diagnose and repair the other DTCs in this module before proceeding.
  No
  - Go To 2
CHECK FOR AN ACTIVE DTC
1. Operate the Passenger Window up and down several times.
2. Wait 30 seconds.
3. With the scan tool, read PDM DTCs.
  Is the DTC active?
  
  Yes
  - Go To 3
  No
  - Perform the TESTING FOR AN INTERMITTENT CONDITION procedure. Refer to TESTING FOR AN INTERMITTENT CONDITION .
RESET THE WINDOW MODULE
1. With the scan tool in the Vehicle View screen, select the Diagnostic Procedures tab and perform the "Reset ECU" routine to the Door Module.
2. After the ECU reset routine is completed, start the engine or connect a battery charger and set at charging voltage.
3. Sit in the driver seat and close the doors.
4. Using the window switch, move the passenger window part way down.
5. Using the window switch, raise the window to the full up position and continue to hold the switch for an additional two seconds.
6. Lower the window to the full down position by pushing down on the window switch to its second detent and continue to hold the switch for an additional two seconds.
7. Lift the window switch to the express up position and release.
  Did the window move to the full up position?
  
  Yes
  - Perform the TESTING FOR AN INTERMITTENT CONDITION procedure. Refer to TESTING FOR AN INTERMITTENT CONDITION .
  No
  - Replace the Passenger Door Module in accordance with the Service Information. Refer to MODULE, DOOR (DDM/PDM), REMOVAL AND INSTALLATION .
  - Perform the BODY VERIFICATION TEST. Refer to BODY VERIFICATION TEST .