LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Chrysler >> 2021 >> Voyager LXi, Gas >> Repair and Diagnosis (Single Page) >> Accessories & Equipment >> Communication Devices >> Electronic Control Modules (Service Information) >> Module, Security Gateway (SGW) >> Removal And Installation >> Installation

Removal And Installation: Installation

NOTE:

If a NEW  Security Gateway (SGW) module is being installed, use the diagnostic scan tool to flash the module. Failure to flash the module will leave the SGW module in a locked mode preventing SGW module operation.

  1. Position the SGW module.
  2. Connect the SGW module wire harness connectors.
  3. Install the SGW module retaining bolts and tighten securely.
  4. Install the ICS. Refer to MODULE, INTEGRATED CENTER STACK (ICSM), REMOVAL AND INSTALLATION .
  5. Connect the negative battery cable. If equipped with an Intelligent Battery Sensor (IBS), connect the IBS connector.
  6. If a NEW  SGW module is installed, use the diagnostic scan tool to flash the SGW module.
scientia non olet · About LEMON Manuals