Diagnostic Test

CHECK FOR AN ACTIVE DTC
NOTE:
Make sure that the battery is fully charged before proceeding.
1. With the scan tool, read RCCC DTCs and record on the repair order.
2. With the scan tool, erase DTCs.
3. Start the engine.
4. Allow the engine to idle for two minutes.
5. Using the recorded Environmental Data, along with the When Monitored and Set Conditions above, operate the vehicle in the conditions that set the DTC.
6. With the scan tool, read RCCC DTCs.
  Is the same DTC active?
  
  Yes
  - Go To 2
  No
  - Perform the TESTING FOR AN INTERMITTENT CONDITION procedure. Refer to TESTING FOR AN INTERMITTENT CONDITION .
CHECK FOR POWERTRAIN CONTROL MODULE (PCM) DTCS
1. With the scan tool, read PCM DTCs.
  Are there any battery or charging system DTCs?
  
  Yes
  - Perform the appropriate PCM DTC diagnostic procedure(s). Refer to MODULE, POWERTRAIN CONTROL (PCM), 3.6L .
  No
  - Go To 3
CHECK RELATED HARNESS CONNECTIONS
1. Disconnect all RCCC harness connectors.
2. Disconnect all related in-line harness connections (if equipped).
3. Disconnect the related component harness connectors.
4. Inspect harness connectors, component connectors, and all male and female terminals for the following conditions:
  - Proper connector installation.
  - Damaged connector locks.
  - Corrosion.
  - Other signs of water intrusion.
  - Weather seal damage (if equipped).
  - Bent terminals.
  - Overheating due to a poor connection (terminal may be discolored due to excessive current draw).
  - Terminals that have been pushed back into the connector cavity.
  - Perform a terminal drag test on each connector terminal to verify proper terminal tension.
  Repair any conditions that are found.
5. Reconnect all RCCC harness connectors. Be certain that all harness connectors are fully seated and the connector locks are fully engaged.
6. Reconnect all in-line harness connectors (if equipped). Be certain that all connectors are fully seated and the connector locks are fully engaged.
7. Reconnect all related component harness connectors. Be certain that all connectors are fully seated and the connector locks are fully engaged.
8. With the scan tool, erase DTCs.
9. Using the recorded Environmental Data, along with the When Monitored and Set Conditions above, operate the vehicle in the conditions that set the DTC.
10. With the scan tool, read RCCC DTCs.
  Is the same DTC active?
  
  Yes
  - Replace the Rear Cabin Comfort Controls (RCCC) in accordance with the Service information. Refer to CONTROLS, REAR CABIN COMFORT (RCCC), REMOVAL AND INSTALLATION .
  - Perform the BODY VERIFICATION TEST. Refer to BODY VERIFICATION TEST .
  No
  - Repairing the wiring harness or connections corrected the problem.
  - Perform the BODY VERIFICATION TEST. Refer to BODY VERIFICATION TEST .