Removal And Installation: Installation
- Position the hub and bearing in the steering knuckle.
- Install NEW
hub and bearing to knuckle mounting fasteners (1) and tighten to the proper torque specifications. Refer to FRONT, TECHNICAL SPECIFICATIONS .
- Engage the wheel speed sensor wire to the retainer (1) on the knuckle.
- Connect the wheel speed sensor wire harness connector (1).
- Attach the wheel speed sensor wire retainers (3) on the strut and attach the wheel speed sensor wire retainers (2) to the brake line.
- Install the splash shield (1) and tighten the mounting fasteners (2) to the proper torque specifications. Refer to SHIELD, SPLASH, FRONT WHEELHOUSE
or SHIELD, SPLASH, REAR WHEELHOUSE
.
- Install a NEW
front hub nut (2). While a helper applies the brakes to keep the hub from turning, and tighten to the proper torque specifications. Refer to TORQUE SPECIFICATIONS
.NOTE:
Do not over-torque the hub nut.
- Install the front brake rotor. Refer to ROTOR, BRAKE, REMOVAL AND INSTALLATION .
- Install the tire and wheel assembly. Refer to REMOVAL AND INSTALLATION .
- If necessary, perform a wheel alignment. Refer to WHEEL ALIGNMENT, STANDARD PROCEDURE .
