Front Toe

Center the steering wheel and lock in place using a steering wheel clamp.
NOTE:
Perform the following steps to each side of the vehicle as necessary.

CAUTION:
Do not twist inner tie rod-to-steering gear boots during front wheel Toe adjustment. Remove boot clamps at the inner tie rods and make sure boots moves freely on inner tie rod.

NOTE:
Adjust left front toe first then right front toe.

Courtesy of CHRYSLER GROUP, LLC
Loosen jam nut (1) at inner-to-outer tie rod connection.
Grasp inner tie rod and rotate as necessary to adjust front toe to preferred toe specification. Refer to WHEEL ALIGNMENT, TECHNICAL SPECIFICATIONS .
Tighten tie rod jam nut (1) to the proper torque specification. Refer to FRONT, TECHNICAL SPECIFICATIONS .
Verify the inner tie rod-to-steering gear boot is not twisted, then reinstall boot clamp at inner tie rod.
Adjust front toe on opposite side of vehicle using above procedure as necessary.
Remove steering wheel clamp.
Remove alignment equipment.
Road test vehicle to verify steering wheel is straight and vehicle does not wander or pull.