Removal And Installation - First Or Second Row: Removal

WARNING:

To avoid serious or fatal injury during and following any seat belt or child restraint anchor service, carefully inspect all seat belts, buckles, mounting hardware, retractors, tether straps, and anchors for proper installation, operation, or damage. Replace any belt that is cut, frayed, or torn. Straighten any belt that is twisted. Tighten any loose fasteners. Replace any belt that has a damaged or ineffective buckle or retractor. Replace any belt that has a bent or damaged latch plate or anchor plate. Replace any child restraint anchor or the unit to which the anchor is integral that has been bent or damaged. Never attempt to repair a seat belt or child restraint component. Always replace damaged or ineffective seat belt and child restraint components with the correct, new and unused replacement parts listed in the Mopar® Parts Catalog. Failure to follow these instructions may result in possible serious or fatal injury.

Courtesy of CHRYSLER GROUP, LLC

Remove the protective cover (1) to expose the fastener on the applicable seat belt turning loop.

Courtesy of CHRYSLER GROUP, LLC
Remove the fastener (1) that secures the seat belt turning loop (2) to the height adjuster.
Remove the seat belt turning loop (2) from the height adjuster.
Remove the trim from the inside of the applicable upper pillar. Refer to PANEL, B-PILLAR TRIM, UPPER, REMOVAL AND INSTALLATION .

Courtesy of CHRYSLER GROUP, LLC
Remove the fasteners (1) that secure the height adjuster (2) to the upper inner pillar.
Remove the seat belt turning loop height adjuster from the pillar.