LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Chrysler >> 2021 >> Voyager LXi, Gas >> Repair and Diagnosis >> Restraints >> Restraints Control Systems >> Restraints System (Service Information) >> Sensor, Impact >> Removal And Installation >> C-Pillar Sensor >> Installation

C-Pillar Sensor: Installation

GC0177932Courtesy of CHRYSLER GROUP, LLC
  1. Position the side impact sensor (2) to the inner C-pillar (1). Be certain that the locator pin on the sensor is fully engaged in the locator hole of the inner C-pillar.
  2. Install the screw (4) that secures the sensor (2) to the inner C-pillar (1). Tighten the screw to the proper. Refer to TECHNICAL SPECIFICATIONS .
  3. Connect the body wire harness connector (3) to the sensor connector receptacle.
  4. Install the rear quarter trim panel. Refer to PANEL, QUARTER TRIM, REMOVAL AND INSTALLATION .
  5. Do not connect the negative battery cable at this time. The Supplemental Restraint System (SRS) Verification Test procedure should be performed following service of any SRS component. Refer to STANDARD PROCEDURE .
scientia non olet · About LEMON Manuals