Removal And Installation - Driver Side: Installation
- Position the driver Knee AirBag (KAB) unit (2) below the instrument panel in a vertical orientation with the KAB inflator initiator connector (1) receptacle facing upward.
- Connect the connector insulator (1) of the instrument panel wire harness take out for the driver KAB (2) to the inflator initiator connector receptacle by pressing straight in on the connector. You can be certain that the connector is fully engaged in its receptacle by listening carefully for a distinct, audible click as the connector latches snap into place.
- Carefully position the driver KAB and cover (1) to the lower instrument panel support structure.
- Install the fasteners (2) that secure the driver KAB and cover to the instrument panel support structure and tighten the fasteners to the proper. Refer to TECHNICAL SPECIFICATIONS .
- Install the steering column opening cover to the instrument panel. Refer to COVER, STEERING COLUMN OPENING, REMOVAL AND INSTALLATION .
- Do not connect the negative battery cable at this time. The Supplemental Restraint System (SRS) Verification Test procedure should be performed following service of any SRS component. Refer to STANDARD PROCEDURE .
