LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Chrysler >> 2021 >> Voyager LXi, Gas >> Repair and Diagnosis >> Restraints >> Air Bag, SRS >> Restraints System (Service Information) >> Air Bag, Seat >> Removal And Installation >> Installation

Removal And Installation: Installation

GC0177776Courtesy of CHRYSLER GROUP, LLC
  1. Position the Seat AirBag (SAB) (1) close enough to the outboard side of the seat back frame to connect the seat wire harness connector (2) to the SAB inflator. Be certain that the connector latches and lock are fully engaged.
    GC0177415Courtesy of CHRYSLER GROUP, LLC
  2. Position the SAB to the outboard side of the seat back frame and insert the studs through the mounting holes in the frame.
  3. Install the fasteners (2) that secure the SAB to the inside of the seat back frame (1) and tighten securely.
  4. Install the seat back cover and plastic frame to the front seat back. Refer to COVER, SEAT BACK, FRONT, REMOVAL AND INSTALLATION .
  5. Do not connect the negative battery cable at this time. The Supplemental Restraint System (SRS) Verification Test procedure should be performed following service of any SRS component. Refer to STANDARD PROCEDURE .
scientia non olet · About LEMON Manuals