Second Row Outboard: Removal
To avoid serious or fatal injury during and following any seat belt or child restraint anchor service, carefully inspect all seat belts, buckles, mounting hardware, retractors, tether straps, and anchors for proper installation, operation, or damage. Replace any belt that is cut, frayed, or torn. Straighten any belt that is twisted. Tighten any loose fasteners. Replace any belt that has a damaged or ineffective buckle or retractor. Replace any belt that has a bent or damaged latch plate or anchor plate. Replace any child restraint anchor or the unit to which the anchor is integral that has been bent or damaged. Never attempt to repair a seat belt or child restraint component. Always replace damaged or ineffective seat belt and child restraint components with the correct, new and unused replacement parts listed in the Mopar® Parts Catalog. Failure to follow these instructions may result in possible serious or fatal injury.
- Remove the appropriate left or right quarter trim panel. Refer to PANEL, QUARTER TRIM, REMOVAL AND INSTALLATION
.
- Remove the protective cover (1) to expose the fastener for the seat belt turning loop (3) on the C-pillar height adjuster (2).
- Remove the fastener (1) that secures the seat belt turning loop (3) to the C-pillar height adjuster (2).
- Remove the seat belt turning loop (3) from the C-pillar height adjuster (2).
- Remove the fastener (5) that secures the retractor (6) to the bracket (4) on the inner body quarter panel.
- Remove the fastener (2) that secures the second row outboard seat belt lower anchor (1) near the base of the C-pillar.
- Remove the second row outboard seat belt and retractor from the vehicle as a unit.
