LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Chrysler >> 2021 >> Voyager LXi, Gas >> Repair and Diagnosis >> Heating, Ventilation & A/C (HVAC) >> General Servicing >> Heating & Air Conditioning (Service Information) >> Controls, Front >> Sensor, Evaporator Temperature >> Removal And Installation >> Removal

Removal And Installation: Removal

WARNING:

Disable the airbag system before attempting any steering wheel, steering column, or instrument panel component diagnosis or service. Disconnect and isolate the negative battery (ground) cable, then wait two minutes for the airbag system capacitor to discharge before performing further diagnosis or service. This is the only sure way to disable the airbag system. Failure to take the proper precautions could result in accidental airbag deployment and possible serious or fatal injury.

  1. Disconnect and isolate the negative battery cable. If equipped with an Intelligent Battery Sensor (IBS), disconnect the IBS connector first before disconnecting the negative battery cable.
  2. Remove the glove box. Refer to GLOVE BOX, INSTRUMENT PANEL, REMOVAL AND INSTALLATION .
  3. Remove the right side console closeout cover.
    GC0177539Courtesy of CHRYSLER GROUP, LLC
  4. Rotate the evaporator temperature sensor (1) counter-clockwise 45 degrees to disengage from the Heating, Ventilation and Air Conditioning (HVAC) housing.
  5. Remove the evaporator temperature sensor (1) from the HVAC housing.
  6. Disconnect the wire harness connector (2) from the evaporator temperature sensor.
scientia non olet · About LEMON Manuals