LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Chrysler >> 2021 >> Voyager LXi, Gas >> Repair and Diagnosis >> Heating, Ventilation & A/C (HVAC) >> General Servicing >> Heating & Air Conditioning (Service Information) >> Distribution, Front >> Motor, Blower >> Removal And Installation >> Removal

Removal And Installation: Removal

WARNING:

Disable the airbag system before attempting any steering wheel, steering column, or instrument panel component diagnosis or service. Disconnect and isolate the negative battery (ground) cable, then wait two minutes for the airbag system capacitor to discharge before performing further diagnosis or service. This is the only sure way to disable the airbag system. Failure to take the proper precautions may result in accidental airbag deployment and possible serious or fatal injury.

  1. Disconnect and isolate the negative battery cable. If equipped with an Intelligent Battery Sensor (IBS), disconnect the IBS connector first before disconnecting the negative battery cable.
  2. Remove the passenger side knee blocker air bag. Refer to AIR BAG, KNEE BLOCKER, REMOVAL AND INSTALLATION .
  3. Remove the right side floor distribution duct. Refer to DUCT, FLOOR DISTRIBUTION, REMOVAL AND INSTALLATION .
    GC0177362Courtesy of CHRYSLER GROUP, LLC
  4. Disconnect the wire harness connector (1) from the blower motor.
  5. Remove the screws (2) that secure the blower motor housing (3) to the HVAC housing and remove the blower motor housing.
scientia non olet · About LEMON Manuals