LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Chrysler >> 2021 >> Voyager LXi, Gas >> Repair and Diagnosis >> Heating, Ventilation & A/C (HVAC) >> A/C Compressor >> Heating & Air Conditioning (Service Information) >> Controls, Front >> Actuator, Mode Door, Front >> Removal And Installation >> Removal

Removal And Installation: Removal

WARNING:

Disable the airbag system before attempting any steering wheel, steering column, or instrument panel component diagnosis or service. Disconnect and isolate the negative battery (ground) cable, then wait two minutes for the airbag system capacitor to discharge before performing further diagnosis or service. This is the only sure way to disable the airbag system. Failure to take the proper precautions may result in accidental airbag deployment and possible serious or fatal injury.

  1. Disconnect and isolate the negative battery cable. If equipped with an Intelligent Battery Sensor (IBS), disconnect the IBS connector first before disconnecting the negative battery cable.
  2. Remove the steering column opening cover. Refer to COVER, STEERING COLUMN OPENING, REMOVAL AND INSTALLATION .
    GC0177729Courtesy of CHRYSLER GROUP, LLC
  3. Disconnect the mode door actuator wire harness connector (5).
  4. Remove both demister and defrost lever bolts (4) and remove the two levers (3).
    NOTE:

    The mode door actuator is serviced with the bracket and CAM assembly also.

  5. Remove the mode door actuator bracket bolts (1) and remove the mode door actuator assembly (2).
scientia non olet · About LEMON Manuals