LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Chrysler >> 2021 >> Voyager LXi, Gas >> Repair and Diagnosis >> Heating, Ventilation & A/C (HVAC) >> A/C Compressor >> Heating & Air Conditioning (Service Information) >> Controls, Rear >> Actuator, Mode Door, Rear >> Removal And Installation >> Removal

Removal And Installation: Removal

  1. Disconnect and isolate the negative battery cable. If equipped with an Intelligent Battery Sensor (IBS), disconnect the IBS connector first before disconnecting the negative battery cable.
  2. Remove the right rear wheelhouse splash shield. Refer to SHIELD, SPLASH, REAR WHEELHOUSE, REMOVAL AND INSTALLATION .
    GC0178152Courtesy of CHRYSLER GROUP, LLC
  3. Remove the A/C line to body nut (1).
    NOTE:

    This step is necessary to prevent damage to the A/C lines in Step 7  .

  4. Remove the rear floor distribution duct. Refer to DUCT, FLOOR DISTRIBUTION, REAR, REMOVAL AND INSTALLATION .
  5. Remove the rear ceiling distribution duct. Refer to DUCT, CEILING DISTRIBUTION, REMOVAL AND INSTALLATION .
    GC0178220Courtesy of CHRYSLER GROUP, LLC
  6. Remove the Heating, Ventilation and Air Conditioning - Rear (HVACR) housing to inner quarter panel bolts (2).
  7. Carefully pull the top of HVACR housing 3 inches away from the rear inner quarter panel to gain access to the actuator fasteners and wire harness connector.
    NOTE:

    Extending the HVACR housing greater than 3 inches from the rear inner quarter panel could result in damage to the A/C lines.

    GC0178354Courtesy of CHRYSLER GROUP, LLC
  8. Disconnect the mode door actuator wire harness connector (1).
  9. Remove the mode door actuator to HVACR housing screws (3) and remove the actuator.
scientia non olet · About LEMON Manuals