LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Chrysler >> 2021 >> Voyager LXi, Gas >> Repair and Diagnosis >> Heating, Ventilation & A/C (HVAC) >> A/C Compressor >> Heating & Air Conditioning (Service Information) >> Plumbing, Front >> Line, A/C Discharge >> Removal And Installation >> Removal

Removal And Installation: Removal

WARNING:

Review the safety precautions and warnings in this article before performing this procedure. Failure to follow these instructions may result in serious or fatal injury.

GC0171954Courtesy of CHRYSLER GROUP, LLC
  1. Recover the refrigerant from the refrigerant system. Refer to PLUMBING, FRONT, STANDARD PROCEDURE .
  2. Disconnect and isolate the negative battery cable. If equipped with an Intelligent Battery Sensor (IBS), disconnect the IBS connector first before disconnecting the negative battery cable.
  3. Remove the front engine belly pan. Refer to BELLY PAN, ENGINE, REMOVAL AND INSTALLATION .
  4. Remove the front belly pan. Refer to BELLY PAN, FRONT, REMOVAL AND INSTALLATION .
  5. Remove the bolt (5) that secures the A/C discharge line (1) to the condenser (4).
  6. Disconnect the A/C discharge line (1) from the A/C condenser (4).
  7. Remove the bolt (3) that secures the A/C suction line and A/C discharge line (1) to the A/C compressor (2).
  8. Disconnect the A/C suction line and A/C discharge line (1) from the A/C compressor (2). Separate the A/C suction line and A/C discharge line (1).
  9. Remove the A/C discharge line (1) from the engine compartment. Remove and discard  the O-ring seals.
  10. Install plugs in, or tape over the open refrigerant line fittings, the condenser and compressor ports.
scientia non olet · About LEMON Manuals