Removal And Installation: Installation
- Lubricate the rubber mount sockets on the resonator with Mopar® Rubber Bushing Installation Lube.
- Install the resonator to the throttle body inlet. Push the resonator down onto the two locating pins on the right cylinder head cover until the rubber mount sockets are fully seated.
- Install the bolt (1) and tighten to the proper torque specification. Refer to TECHNICAL SPECIFICATIONS .
- Tighten the clamp (2) to the proper torque specification. Refer to TECHNICAL SPECIFICATIONS .
- if removed, install the Inlet Air Temperature (IAT) sensor (1) by turning the sensor 1/4 turn in the clockwise direction.
- Engage the wire harness retainer (2) to the resonator.
- Connect the electrical connector to the IAT sensor (1).
- Install the hose to the resonator and tighten the clamp (1) to the proper torque specification. Refer to TECHNICAL SPECIFICATIONS .
- Install the engine cover. Refer to COVER, ENGINE, REMOVAL AND INSTALLATION .
- Connect the negative battery cable. If equipped with an Intelligent Battery Sensor (IBS), connect the IBS connector.
