Removal And Installation: Installation
NOTE:
The LH cylinder head hydraulic lifters are shown in illustration, the RH cylinder head hydraulic lifters are similar. If the hydraulic lifters are being reused, reassemble them into their original locations.
NOTE:
The exhaust hydraulic lifter must never be interchanged with any other hydraulic lifter than what is specifically designated for this vehicle. The internal check ball is reversed and could cause engine damage if an incorrect part is installed.
- Verify that the hydraulic lifters are at least partially full of oil. There should be little or no plunger travel with the intake hydraulic lifter is depressed and there should be some plunger travel with the exhaust hydraulic lifter.
- Install the intake hydraulic lifter(s) (1).NOTE:
If the rocker arms are being reused, reassemble them into their original locations.
- The exhaust hydraulic lifters (1) are installed with the rocker arms, as they are attached to the rocker arm with a clip.
- Install the rocker arm(s). Refer to ROCKER ARM, VALVE, REMOVAL AND INSTALLATION .
- Install the camshaft(s), phasers, cylinder head cover(s) and upper intake manifold. Refer to CAMSHAFT, ENGINE, REMOVAL AND INSTALLATION .
