Removal And Installation: Removal
- Remove the third row Stow-N-Go seat from the vehicle. Refer to SEAT, STOW-N-GO, REMOVAL AND INSTALLATION .
- Using a trim tool, remove the end clip from the soft cover (2), and remove the screw (1).
- Pull at the front of the side cover (3) to release the clip, then lift off the recliner to remove. Remove both side covers.
- Remove the two screws (1).
- Pull at the bottom of the cover (3) to release the clips, then lift to remove from the seat frame.
- Using a trim stick, release the clips and remove the hinge cover (1).
- Using a trim stick, release the clips and loosen the leg cover (3), then remove the seat panel (2).
- Using a hook tool, release all the seat cushion cover retainers (1).
- Pull the seat cover (3) from around the trim support (2).
- Lift the trim support at the front (1), then push rearward and remove it from the frame.
- Remove the seat cushion and cover from the seat cushion frame as an assembly.NOTE:
Be careful not to damage the clips molded into the seat cushion. If the clips or cushion are damaged during removal, replace the cushion.
- Pull the cover (2) from the foam. Use a hook tool to release the clip strip (1). Pull to release the hook and loop fasteners (3).
