Removal And Installation: Installation

Courtesy of CHRYSLER GROUP, LLC

Locate the flattened end of the steel rod (3) on the right hand side of the sunshade and insert it into the slot in the bracket.

Courtesy of CHRYSLER GROUP, LLC
With the sunshade (1) held firmly, push the sunshade inward to release the sunshade spring lock.
If the steel pin is pushed in before it engages in the bracket, the sunshade has to be re-wound. Refer to SUNSHADE, SUNROOF, STANDARD PROCEDURE .

Courtesy of CHRYSLER GROUP, LLC
Push the left side of the sunshade (3) down until the white pivot pin snaps into the pivot bracket.

Courtesy of CHRYSLER GROUP, LLC
Insert the white clip (4) with the slot (1) located at the sew line (2). Do this on both sides of the sunshade.
Extend the front sunshade beam forward and work the fabric (3) under the guide.
Slide the sunshade and white clips forward onto the guide (5). Do this on both sides of the sunshade.

Courtesy of CHRYSLER GROUP, LLC
Rotate the front sunshade beam (3) onto the retainer until the tab (2) snaps into place.
Position the rear glass and loosely install the fasteners.
Tighten the rear glass fasteners to the proper specification. Refer to TECHNICAL SPECIFICATIONS .
Install the front glass panel. Refer to GLASS, SUNROOF, FRONT, REMOVAL AND INSTALLATION .
Adjust the glass panes. Refer to GLASS, SUNROOF, REAR, ADJUSTMENTS .