LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Chrysler >> 2021 >> Voyager LXi, Gas >> Repair and Diagnosis >> Body & Frame >> Seats >> Body - Interior & Exterior >> Seats, First Row >> Cover, Seat Back, Front >> Removal And Installation >> Removal

Removal And Installation: Removal

WARNING:

Disable the airbag system before attempting any front seat diagnosis or service. Disconnect and isolate the negative battery (ground) cable and wait two minutes for the airbag system capacitor to discharge before performing further diagnosis or service. This is the only sure way to disable the airbag system. Failure to follow these instructions may result in accidental airbag deployment and possible serious or fatal injury.

GC0177563Courtesy of CHRYSLER GROUP, LLC
  1. Before proceeding with the following repair procedure, review all warnings and cautions. Refer to SEATS, FIRST ROW, WARNING .
  2. Remove the armrest. Refer to ARMREST, FRONT, REMOVAL AND INSTALLATION  or ARMREST, REAR, WITH RECLINE, REMOVAL AND INSTALLATION .
  3. Remove the front seat back panel, if equipped. Refer to PANEL, SEAT BACK, FRONT, REMOVAL AND INSTALLATION .
  4. Remove the front seat back. Refer to SEAT BACK, FRONT, REMOVAL AND INSTALLATION .
  5. On seats without a seat back panel, open the zippers on each side of the seatback cover and release the cover J-hooks.
  6. Push the tab of the headrest sleeves (1) and pull out to remove.
  7. Remove the five push fasteners (2).
  8. Release the J-hook retainers (3) for the seat back cover (4).
    GC0177690Courtesy of CHRYSLER GROUP, LLC
  9. Using a trim stick, separate the seat back ventilation (2) from the fan motor (1), if equipped.
    GC0177602Courtesy of CHRYSLER GROUP, LLC
  10. Remove the six screws (1) and the plastic frame (2).
    GC0177761Courtesy of CHRYSLER GROUP, LLC
  11. Remove the seat air bag from the seat back frame, following all warnings and cautions. Refer to AIR BAG, SEAT, REMOVAL AND INSTALLATION .
  12. Remove the seat air bag nuts (1).
    GC0177346Courtesy of CHRYSLER GROUP, LLC
  13. Pull back the seat back cover and disconnect the wire harness connector (2) from the seat air bag.
  14. Remove the seat air bag from the chute (1) and set aside.
    GC0177311Courtesy of CHRYSLER GROUP, LLC
  15. Disconnect the seat back heater wire harness connect (1), if equipped.
    GC0177909Courtesy of CHRYSLER GROUP, LLC
    NOTE:

    Be careful not to damage the clips molded into the seat cushion. If the clips or cushion are damaged during removal, replace the cushion.

  16. Remove the seat back foam and seat back cover as an assembly, from the seat back frame.
  17. Pull the seat back cover (3) away from the seat foam, releasing the hook and loop fasteners (1) first.
  18. Using a hook tool, start at one end to release the clip strips (2) and the seat back cover.
scientia non olet · About LEMON Manuals