LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Chrysler >> 2021 >> Voyager LXi, Gas >> Repair and Diagnosis >> Accessories & Equipment >> Gauges & Instrument Panels >> Body - Interior & Exterior >> Interior >> Headliner >> Removal And Installation >> Installation

Removal And Installation: Installation

NOTE:

In the event the headliner is damaged or creased during installation, it will need to be replaced with a new headliner.

Use clean gloves or make sure your hands are clean before removing the headliner.

GC0177572Courtesy of CHRYSLER GROUP, LLC
  1. Headliner shown in illustration lowered for reference. (1) is a locating pin at the front. (2) shows multiple hook and loop fasteners. (3) is the heater control bracket that engages into the roof panel. (4) is the locating pin/push fastener at the rear. (5) is the rear window washer hose.
  2. With the help of an assistant, position the headliner into the vehicle and connect the rear window washer hose.
    GC0177476Courtesy of CHRYSLER GROUP, LLC
  3. Raise the headliner engaging the front locating pin (4) and the rear locating pin (1).
    NOTE:

    If the vehicle is equipped with a sunroof, there is a safety tether on the right side that needs to be attached to the sunroof frame.

  4. Engage the heater control bracket (3) into the roof panel, then the hook and loop fasteners around the sunroof openings (2 and 5).
  5. Engage the remainder hook and loop fasteners.
    GC0177725Courtesy of CHRYSLER GROUP, LLC
  6. Connect the wire harness connectors (1) and route the wire harness to the passenger side A-pillar.
  7. Connect the rear washer hose (2) and route the hose to the passenger side A-pillar.
  8. Install the rear auxiliary duct.
  9. Install the passenger side rear quarter trim panel. Refer to PANEL, QUARTER TRIM, REMOVAL AND INSTALLATION .
    GC0177239Courtesy of CHRYSLER GROUP, LLC
  10. Install the coat hook (2), screw (1) and the screw cover.
    GC0188579Courtesy of CHRYSLER GROUP, LLC
  11. If equipped with grab handles, Position grab handle (3) in headliner, install the two screws (2) and tighten securely. Install screw covers (1).
  12. If equipped, install the rear interior camera. Refer to CAMERA, REAR INTERIOR, REMOVAL AND INSTALLATION .
  13. Install the overhead console. Refer to CONSOLE, OVERHEAD, FRONT, REMOVAL AND INSTALLATION .
  14. Install the visor supports. Refer to SUPPORT, VISOR, REMOVAL AND INSTALLATION .
  15. Install the visors. Refer to VISOR, REMOVAL AND INSTALLATION .
  16. Install the D-pillar trim panels and the D-pillar trim extensions. Refer to PANEL, D-PILLAR TRIM, REMOVAL AND INSTALLATION .
  17. Install the C-pillar trim panels and the C-pillar trim extensions. Refer to PANEL, C-PILLAR TRIM, REMOVAL AND INSTALLATION .
  18. Install the upper B-pillar trim panels. Refer to PANEL, B-PILLAR TRIM, UPPER, REMOVAL AND INSTALLATION .
  19. Install the A-pillar trim panels. Refer to PANEL, A-PILLAR TRIM, REMOVAL AND INSTALLATION .
  20. Connect the negative battery cable. If equipped with an Intelligent Battery Sensor (IBS), connect the IBS connector.
scientia non olet · About LEMON Manuals