LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Chrysler >> 2021 >> Voyager LXi, Gas >> Repair and Diagnosis >> Accessories & Equipment >> Exterior Lights >> Lamps/Lighting - Exterior (Service Information) >> Switch, Headlamp >> Removal And Installation >> Installation

Removal And Installation: Installation

WARNING:

To avoid serious or fatal injury on vehicles equipped with airbags, disable the Supplemental Restraint System (SRS) before attempting any steering wheel, steering column, airbag, seat belt tensioner, impact sensor or instrument panel component diagnosis or service. Disconnect and isolate the battery negative (ground) cable, then wait two minutes for the system capacitor to discharge before performing further diagnosis or service. This is the only sure way to disable the SRS. Failure to take the proper precautions could result in accidental airbag deployment.

  1. Snap the headlamp switch into the steering column opening cover confirming that all of the retainers are engaged and seated properly to the steering column opening cover.
  2. Connect the wire harness connector to the back of the headlamp switch.
  3. Install the steering column opening cover. Refer to COVER, STEERING COLUMN OPENING, REMOVAL AND INSTALLATION .
scientia non olet · About LEMON Manuals