Removal And Installation: Installation

Courtesy of CHRYSLER GROUP, LLC

1. Position the fold and stow module (2) to the bottom of the seat for installation.
2. Install the stow and go module engaging the rear tabs first before engaging the front tab (3) on the module to the seat.
3. Connect the wiring harness connector (1) to the fold and stow module.

   Courtesy of CHRYSLER GROUP, LLC

4. Install the seat bottom panel (1).
5. Unstow the 60 percent 3rd row seat assembly.
6. Connect the negative battery cable.

When the seat is replaced or the module is updated or replaced, perform the following calibration procedures using the scan tool: 

• Calibrate Full Recline
• Calibrate Stow
• Write Left Rear Seat Position
• Write Right Rear Seat Position